Anritsu Tech Day

Haasteita 5G-verkkojen kenttämittauksen kanssa? Tule hakemaan ratkaisu Vantaalta 12.3.2024 päämiehemme Anritsun kanssa järjestettävästä maksuttomasta koulutuspäivästä.

Ilmoittaudu heti
16.1.2024

5G-verkkojen kenttämittaus

Järjestämme päämiehemme Anritsun kanssa Tech Dayn, joka keskittyy 5G-verkkojen kenttämittaukseen.

Päivä tarjoaa kattavan paketin koulutusta ja ratkaisuja haasteisiin, joita verkko-operaattorit, urakoitsijat ja sääntelystä vastaavat viranomaiset kohtaavat päivittäisessä työssään. Myös verkostoitumiselle on varattu aikaa.

Käsittelemme mm. seuraavia aiheita:

  • 5G-verkon laadun ja toiminnan varmistaminen kenttämittauksin
  • Sisä- ja ulkoverkon kuuluvuuskartoituksen suorittaminen
  • 5G-verkon häiriösignaalien tunnistaminen
  • Passiivisen intermodulaation (PIM) syiden tutkiminen ja ratkaisut

Tarkempi ohjelma alla. Tapahtuma järjestetään englanniksi. Aloitamme klo 9 aamukahvien merkeissä, mutta olet tervetullut saapumaan joustavasti itsellesi sopivaan aikaan.

Päivämäärä: tiistai 12.3.2024
Aika: klo 9–16
Paikka: Orbis Oy, Vanha Kaarelantie 9, Vantaa

Varaa paikkasi

Tapahtuma on täynnä!

Voit tiedustella peruutuspaikkoja asiakaspalvelustamme: asiakaspalvelu@orbis.fi, p. +358 20 478 8600.

Päivän ohjelma (englanniksi)

Voit myös ladata ohjelman pdf:nä tästä.

9:00–9:15 Welcome & Introduction

9:15–10:50 Session One | Ensuring Performance of 5G Network with Accurate Field Measurements
Johan Wallblad, Field Application Engineer, Anritsu

As 5G networks are being widely deployed around the world, the cellular network operators, their subcontractors, and the National Regulator Authorities need to ensure that the networks are functioning well by measuring certain RF metrics in the field. This session will be focused on detailing and explaining the various key RF measurements that need to be done to qualify how good a 5G network is. To illustrate how a 5G cell behaves, various Anritsu measurement tools, like the spectrum analyzer, the real time spectrum analyzer, and the 5G demodulation software capabilities, will be demonstrated.

10:50–11:05 Coffee Break

11:05–11:45 Session Two | Performing Indoor and Outdoor Network Coverage Mapping
Johan Wallblad, Field Application Engineer, Anritsu

Once networks are being deployed, cellular network operators always need to verify how good the outdoor or indoor level reception of their network is either by performing some drive tests or manual testing in buildings. There are different kinds of tools to make these measurements. One of these tools is a spectrum analyzer which can demodulate 5G carriers for instance and can be remotely controlled to measure and store these metrics which could then be post-processed on a map.
This session will illustrate a solution called NEON associated with Anritsu Spectrum Analyzers MS2090A and MS2080A. NEON allows both an indoor measurement session inside a building across all floors even when a geolocation with GNSS is impossible and outdoor measurements being collected by car rather than through long pedestrian walks. 2D and 3D maps can then be displayed on a computer for further processing and reporting.

11:45–12:15 Live Demonstrations

12:15–13:15 Lunch

13:15–14:00 Session Three | Isolating Interference in 5G
Johan Wallblad, Field Application Engineer, Anritsu

One of the main difficulties with TDD networks is the ability to isolate a potential interference frequency in a 5G frame to locate it in the field. The network can’t be stopped to let this interference appearing alone in the spectrum band which normally affects the uplink part. Due to the TDD particularity, in case an interference exists, it makes it more difficult for 5G subscribers to connect to the network with their devices.
An Interference Hunting technique will be proposed during this session based on the latest generation of handheld spectrum analyzers. It will highlight how to operate with the unit to put in evidence if any unwanted carrier affects the UL part of a TDD frame.

14:00–14:15 Coffee Break

14:15–15:00 Session Four | Examination of Passive Intermodulation Causes
Johan Wallblad, Field Application Engineer, Anritsu

For FDD networks, another RF phenomenon could disturb the networks when they are aging or not well maintained over time: the Passive Intermodulation (aka. PIM).
During this session, we will explain the potential causes of these interferences and how these can be fixed in the field by using a dedicated test instrument called the PIM Master.

15:00–15:30 Live Demonstrations and Q&A

15:30–16:00 Closing Speech

Kysyttävää?

Ota yhteyttä asiantuntijoihimme.

Pasi Hopponen

avainasiakaspäällikkö

+358 400 411 198

etunimi.sukunimi@orbis.fi

Minulla on reilun 20 vuoden kokemus teleoperaattoreiden mobiileista- ja kiinteistä verkoista sekä valokuituteknologiasta.

Harri Mutanen

avainasiakaspäällikkö

+358 400 432 576

etunimi.sukunimi@orbis.fi

Tarvitsetko ratkaisua kiinteistöjen tiedonsiirtoon? Minulla on yli 10 vuoden kokemus kiinteistöjen tiedonsiirron valokuituratkaisuista ja mittauslaitteista. Lisäksi Traficomin sisäverkkomääräys M65 on arkipäivääni. Näissä asioissa jatketaan keskusteluja!

Teemu Vahtola

Teemu Vahtola

tekninen myyjä

+358 40 643 2068

etunimi.sukunimi@orbis.fi